Re: Issue with Parameter Update
Hi Ratnakar, You are sending only two parameter values so it updates first two on SAP EM info table. You have done custom extraction to update in SAP ECC side, however SAP EM was updated previously...
View ArticleRe: Issue with Parameter Update
Hi Ratnakar, you have to define the logic in application system create and delete the old parameter during the change update triggered by actions or in update task of EM EH logic required to delete or...
View ArticleRe: Issue with Parameter Update
Hi Ratnakar, you have to set Parameter Action to D: Parameter Name Parameter Value Parameter Index ActionX E 1X F...
View ArticleRe: Issue with Parameter Update
Hi, Thanks Sukumar, Gopi and Steffen for suggesting various ways to fix the issue. Actually I was exploring the EM-AI (as mentioned by Steffen) and Ruleset (as mentioned by Gopi), but I thought there...
View ArticleRe: Issue with Parameter Update
Hi Ratna, The ruleset config with custom function would be best as if tomorrow any requirement change, it would enable you to remove activity function and ruleset seamlessly. RegardsGGOPII
View ArticleRe: Issue with Parameter Update
Hi Gopi, i don't thin rule set is the best solution here. With rule set you would need an extra event message. Best regards,Steffen
View ArticleRe: Issue with Parameter Update
Hi Steffen, Basically this particular info parameter is getting updated through BAPI_EH_POST at a later time as per design. So Would not it be fine to reset the value through EH Update...
View ArticleRe: Issue with Parameter Update
Hi Steffen, We don't require separate event message to populate as we can incorporate into existing event messages to update. RegardsGGOPII
View ArticleRe: Issue with Parameter Update
Hi Ratnakar, Just to clear confusion, is there any event being posted here? Gopi thinks there will be an event in your process but based on your questions I am assuming there is no event here. In the...
View ArticleRe: Issue with Parameter Update
Hi Ratnakar, I was just wondering, if the issue has been solved? From my point of view you should either - not use the "Define SAP EM Data Extraction", but instead implement the extraction in custom...
View Article